Cleaning Your Atomizer
Cleaning the atomizer is relatively simple and should be done regularly to keep your tank working well and your vapor tasting as it should.
Here’s a step-by-step guide to getting that atomizer tank squeaky clean.
1. First, whether it’s fresh from the box or your old, trusty tank, you need to take it apart. This includes removing the o-rings and the screws. This part’s important – remember where everything goes. Draw yourself a diagram if needed.
2. Using a clean container, pour a 90% alcohol solution into it and add your tank parts. Give them a quick rinse to remove any leftover oils.
3. Empty the alcohol container and fill it again with enough warm water to cover all the parts. Add some of that handy dish soap and mix it in the water with a spare toothbrush. Let the parts soak for as long as your tank manufacturer recommends.
4. Soaking is done. Now, take that spare toothbrush and gently scrub all the parts. Be sure to pay careful attention to the inner parts that air will be flowing over.
5. Rinse the parts well and lay out to dry on a paper towel or other cloth. Microfiber works well here.
6. Atomizer, assemble! If only just saying that worked. It’s time to put all the parts back together. Either trust your memory or grab that handy diagram you made earlier. First, your o-rings might be a little difficult to insert after they are cleaned. A simple solution is to use some e-juice or vegetable grease to lube them up.
7. Once your o-rings are properly lubed, continue with assembly until it is complete. Remember to install a fresh coil.
Now that you’re fully assembled, it’s time to enjoy a flavorful hit of vape! Want more atomizer options? The Eleaf® iStick E-Cigarettes Vape Online Store is available in different options.
Here’s a step-by-step guide to getting that atomizer tank squeaky clean.
1. First, whether it’s fresh from the box or your old, trusty tank, you need to take it apart. This includes removing the o-rings and the screws. This part’s important – remember where everything goes. Draw yourself a diagram if needed.
2. Using a clean container, pour a 90% alcohol solution into it and add your tank parts. Give them a quick rinse to remove any leftover oils.
3. Empty the alcohol container and fill it again with enough warm water to cover all the parts. Add some of that handy dish soap and mix it in the water with a spare toothbrush. Let the parts soak for as long as your tank manufacturer recommends.
4. Soaking is done. Now, take that spare toothbrush and gently scrub all the parts. Be sure to pay careful attention to the inner parts that air will be flowing over.
5. Rinse the parts well and lay out to dry on a paper towel or other cloth. Microfiber works well here.
6. Atomizer, assemble! If only just saying that worked. It’s time to put all the parts back together. Either trust your memory or grab that handy diagram you made earlier. First, your o-rings might be a little difficult to insert after they are cleaned. A simple solution is to use some e-juice or vegetable grease to lube them up.
7. Once your o-rings are properly lubed, continue with assembly until it is complete. Remember to install a fresh coil.
Now that you’re fully assembled, it’s time to enjoy a flavorful hit of vape! Want more atomizer options? The Eleaf® iStick E-Cigarettes Vape Online Store is available in different options.
No comments